_
English
_
Parts description
1.
Swivel at 360° power cord
2.
ON/OFF switch
3.
Mode selecting switch:
Curling
Adding volume
Straightening
4.
Volume plates (small waves)
5.
Straightening plates
6.
Curling plates
7.
Heat resistant tip.
Instructions for use
Heating the hair styler:
1.
Ensure that the ON/OFF switch is in OFF position.
2.
Fully unwind the power cord and plug in the appliance in a proper outlet. Before
plugging in, ensure that the voltage in your home corresponds with the one indicated on
the rating plate of the appliance.
3.
Switch the ON/OFF switch to ON position. The pilot light will go on and the hair
styler will start heating up.
4.
Ensure that the appliance is placed on a heat resistant surface while it is operating.
Hair styling:
Before straightening, the hair should be washed and completely dry and combed.
The appliance is intended for styling of natural hair only.
Using the comb, divide your hair in several strands (use hairpins if necessary).
Lock a hair strand of approx. 5cm wide between your thumb and middle finger and
press it with the hair styler. To avoid scalding of skin, do not use the hair styler too
close to the skin. Avoid touching the skin of neck and face with the hot surfaces of
the appliance.
Keep the hair straightener plates closed for a few seconds. While pressing the plates,
start slowly to slide the appliance down the hair begging from hair roots to tips.
Except with one hand holding the device handle, you can hold the appliance and with
your other hand at the heat resistant tip (7). Thus you can achieve better results by
distributing the pressure over the plates. Keep the hair straightener plates closed for
maximum 10 seconds in order to avoid damaging you hair.
Repeat this process for the rest of your hair.
Allow your hair to cool down and then use a hair brush or comb to finish the hair
style.
After use
1.
Turn the appliance off by pressing the ON/OFF switch to OFF position.
2.
Let the appliance to cool down for minimum 15 minutes before cleaning or storage.