4
www.zephyronline.com
Installation –
Mounting the Diverter Box
Mounting the air diverter box
FOR USE WITH AK7000BS, AK7500BS, AK7036BS,
AK7536BS, AK7042BS, AK7542BS, AK7048BS and
AK7548BS ONLY
FOR USE WITH SINGLE INTERNAL BLOWER ONLY
NOT COMPATIBLE WITH DUAL INTERNAL BLOWER
1. Position the air diverter box under cabinet. Mark the (4
for 30 & 36” models, 6 for 42” & 48” models) key-holes for
the #6 x 1” screws and electrical knock out opening with a
pencil. Remove air diverter box and install the (4 or 6) #6
x 1” screws. Do not tighten screws all the way. Drill out the
electrical knock-out opening.
Note:
Reinforce cabinet with 1” x 2” wood strips if additional
strengthening is required or if cabinets are framed.
2. Lift air diverter box and align the holes on top of the air
diverter box with the screws recently installed. Slide the air
diverter box towards the wall to temporarily lock in place.
Hand tighten the (4 or 6) screws. (Fig. A)
3. Lift range hood and align the key-holes on top of the hood
with the screws protruding from the bottom of the air diverter
box. Slide hood towards wall to temporarily lock in place.
Hand tighten the (4) screws. (Fig. A)
Note:
Electrical wiring will pass through the cabinet bottom,
air diverter box and connect to the hood wiring. See Tempest
I instruction manual for more details.
4. Further secure the hood to the air diverter box by fastening
M4 x 8 screws and 3/16 x 3/8” screws to each of the (8)
holes on the bottom of the air diverter box. You can gain
access to the screw holes from within the hood. The holes on
top of the Tempest I will align with the holes on the bottom of
the air diverter box. (Fig. B)
(4) M4 x 8 screws go here
(4) 3/16 x 3/8” screws go here
Fig. A
Fig. B
