10
You will notice that we have installed a few components on the PCB already. These components are
(mostly) surface mounted, which are a little more difficult to solder. The square chip in the middle of the
board has been pre-programed with the software your Macchiato needs to run. If you are interested in
changing the way your Macchiato operates then you may want to look into modifying this software and
re-programing the chip. Instructions for this process can be found in the Macchiato Reference Manual.
Let’s begin!
1. Standoffs: Use five of the M3 screws (part #FA-60-37) to attach the five standoffs (part #ST-10-
23) to the circuit board (1,2). Pass the screws through the component side of the board (the side
with the white graphics), and place the standoffs on the solder-side (the blank side) of the board.
1
2
Figure 3: Component Values And Locations