Z 2500-130/150
20
Installation
www.zepro.com
9. When installing on a frame without pre-drilled
holes, install first with a screw in the brackets’
slot-shaped holes. On the vehicle chassis, mark the
middle of the brackets’ slot-shaped holes and then
drill Ø14 mm holes in the frame, see
Image 27.
10. Bolt the brackets securely on the outside of the ve-
hicle chassis. Use M14x45 bolts and install the as-
sociated washer and nut on the inside of the vehicle
chassis. Install the bolts but do not tighten.
11.
Check and perform fine adjustment regarding the
position of the lift. Then tighten the bolts with a
torque wrench.
Tightening torque: 120 Nm
.
12. Using a torque wrench, tighten the bolts holding the
U-profiles.
Tightening torque: 280 Nm.
13. Drill holes in the vehicle chassis for mounting bolts,
Ø14 mm. Drill in the outer holes of each bracket.
Use M14x45 bolts and install the associated
washer and nut on the inside of the vehicle chas-
sis. Installation must be performed with at least 6
bolts in the outer holes. The bolt that was installed
initially in the slot-shaped hole may not be included
in this figure. If necessary, this bolt can now be
moved to one of the outer holes, see illustration.
Then tighten the bolts with a torque wrench.
Tightening torque: 120 Nm.
Welding is not permitted on the chassis brackets.
Do not move the lift all the way to the armstops or
with the platform fitted before all the bolts are fully
tightened against the chassis.
Do not place the lift under load until:
· the correct number of bolts have been installed
and torque-tightened.
· the vehicle body is installed to reinforce the truck
chassis.
NOTE.
14. Remove the mounting jig.
Min. 260
Min. 20
Min.
180
35 mm
Min.
20
Min.
D
D
Min. 6 pcs.
M14x45 10.9
120 Nm
New hole
Image 26.
T
he
chassis bracket requires
at least 35 mm
c
learance between ve-
hicle chassis and support frame
Image 27.
I
nstall the chassis bracket
with at least six M14x45 10.9 bolts
When installing on chassis with pre-drilled holes, go
directly to point 16.
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...