Z 2500-130/150
26
Installation
www.zepro.com
2
3
5
4
End stop
Adjusting collar
Lock screw
4.2.2
Adjusting the downward tilt angle
The tilt angle must be set at 90° to the vehicle body
before the downward tilt angle is adjusted (see
previous page).
NOTE.
To ensure that the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max. 10° if
there are going to be people on the platform.
m
WARNING!
1.
Raise the lift to the vehicle floor.
Image 40
.
2. Loosen the lock screw of the end stop (2). Screw
the end stop all the way back towards the platform
(3).
Image 41
.
3.
Tilt the platform down to max. 10° below the hori
-
zontal.
Image 40
.
4. Adjust the end stop all the way to the top of the
cylinder (4).
Image 41
.
5. Tighten the lock screw in the end stop (5). See
illustration.
Image 41
.
The tightening torque for lock screws is between 3-5 Nm
Test all functions.
Bolt
Washer
Image 40.
T
he tilt angle must be ad-
justed to max.10° down
Image 41.
E
nd stop with lock screw
Image 42.
T
ilt cylinder
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...
