Z 2500-130/150
Installation
31
www.zepro.com
4.7.3
Tail lift with angle sensor IFM for autotilt
1. Install the angle sensor on the platform using the nuts, bolts and washers supplied and attach the cable
using cable time; see
Image 51
2. Route the cables and secure with cable ties
.
Connection is described later in section
6
.
Image 51.
I
nstalling an angle sensor for auto tilt
Bracket on the platform
Autotilt angle setting
By default, the autotilt angle is set to 0°. If necessary, the position
of the angle sensor (autotilt angle) can be adjusted.
1. Loosen the two screws without removing them, see
Image 52
.
2. Adjust the position of the angle sensor to the desired angle,
see
Image 52
.
3. Retighten the screws.
Image 52.
A
djusting the autotilt angle
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...
