Z 2500-130/150
40
Connection
www.zepro.com
6.2
Connection
IMPORTANT!
Make sure that the control board is disconnected from the power before connecting peripheral
equipment. Risk of material damage.
1. Release and tilt out the relay board.
2. Run the cabling through the grommet.
3.
Connect the relevant controller. See Section 6.2.1
-
6.2.2
.
4.
Where applicable, connect the warning lights. See Section 6.2.3
-
6.2.4
.
5. Where appropriate, plug in cab switch (CS) and open platform alarm. See Section
6.2.5
-
6.2.7
.
6.
Route the cabling on the reverse of the control board / relay board and secure it with cable ties. See Image 70
.
7.
Tilt in and secure the
relay board
.
8.
Replace the cable grommet, see Section 6.1.2
.
IMPORTANT!
Ensure that no cables are pinched or in any other way damaged when the control board is tilted out/in.
Image 70.
I
nstalling cabling with cable ties
NOTE!
The illustration shows the ZePRO1 control card, but the operation is the same regardless of the control card /
relay card model.
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...
