Z 2500-130/150
60
Testing and verification
www.zepro.com
11
Testing and verification
Testing and verification of the tail lift takes place in accordance with the installation/delivery inspection. Verify
that the tail lift is suitable for the vehicle in question and for the intended use.
11.1
Static load test
11.1.1
Deformation
Position the tail lift half way up to the vehicle floor level and with the platform in the horizontal position. Measure
dimensions A-B-C-D for comparison as illustrated.
Place a test load on the platform according to the table for the respective tail lift model and lifting capacity.
Remove the test load from the platform.
Repeat the measurement of A-B-C-D and verify that there has been no deformation of the lift or its fixing.
11.1.2
Drift
Place a test load on the platform according to the table. The tail lift must be at the same level and angle as the
vehicle floor. Leave the test load for 15 minutes.
Verify that the platform drift is no more than 15 mm on the vertical (points A and D) and 2º in terms of the angle.
11.1.3
Static load (Test load 1.25 x tail lift loading capacity). For tail lifts with load
centre of 1000 mm
Capacity
Load 1500 kg
Load 2000 kg
Distance out in platform (L)
2500 kg
2120 mm
1560 mm
Image 89.
T
esting and verification
Max 2º
Max. 15 mm
B
D
C
A
B
D
C
A
Vehicle floor le
vel
Deformation
Drift
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...
