Z 2500-130/150
8
Safety rules
www.zepro.com
2
Safety rules
2.1
Moving parts - free movement
m
WARNING!
During final inspection*, the space occupied by the
moving cylinders must be cleared and made safe.
There is a risk of collision between the cylinder and
the following items: subframe, truck chassis, beam
for rear light (number plate) and the chassis bracket
of the lift (with a short overhang).
**Final inspection to be carried out with the platform
at the vehicle floor and tilted down 10°. The clear
-
ance from the closest part of the cylinder must be
at least 40 mm.
m
WARNING!
The platform may not be tilted down more than
10º from the horizontal.
min. 40 mm
10º
10º
Image 5.
C
learance to the closest part of
the cylinder must be at least 40 mm
Image 6.
T
he platform may not be tilted
down more than 10º from the horizontal
2.2
Connection of third-party equipment is forbidden
m
WARNING!
Connecting third-party equipment (electric or hydraulic) to Zepro tail lifts is forbidden. Connecting third-
party equipment could interfere with the lift’s system and its safety functions. Risk of injury and damage. If
it is necessary to install other equipment, check the vehicle manufacturer’s body instructions and use the
attachment features on the vehicle.
2.3
Installation
m
WARNING!
Installation where the platform cannot reach ground level is prohibited.
m
WARNING!
ZEPRO tail lifts are only approved for installation using ZEPRO assembly kits.
IMPORTANT!
All specified tightening torques apply when using torque wrench or screw/nut runner with torque control.
Torque spread max ±5%.
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...
