Z3N/Z3NU/Z3NN/Z3NNU/Z3NW/Z3NWU 75-100
26
Installation
www.zepro.com
4.5
Controllers
1.
Install the primary controller on the side of the vehicle normally facing away from the traffic. The distance
between the vehicle’s rear edge and the centre of the controller must be 300-600 mm. Connection is
performed later in section
6 if this is not already done from the factory.
2. Any additional controllers can be installed in an optional location. Connection is described later in section
6.
IMPORTANT!
The controller’s cable intake must always face downwards.
Pay attention and be careful when running cables to get longer life for the cables and to reduce the risk of unnecessary downtime.
The cable must not be fastened to brake lines or the vehicle’s normal electrical system.
The cable must be protected by rubber grommets when it passes through beams or walls.
Cables must be installed sufficiently far from, or be protected against, sharp edges so they cannot chafe or otherwise sustain
damage that could lead to a short-circuit and cable fires.
Take care not to bend cables with too tight a radius as this can cause damage.
Image 40. Installing controllers
Image 41. Installing controllers
m
WARNING!
The primary controller must always be fitted on the side that is facing away from moving traffic. Fitting in any other way involves
increased risk of injury.
300-600 mm.
Summary of Contents for Z3N 75-100
Page 2: ......
