ZDK 250 135/155
24
Installation
www.zepro.com
4.2.1
Adjusting the tilt angle
IMPORTANT
!
Make no adjustments to the cylinders before installing
them on the platform. The tilt cylinders are factory preset.
1. Loosen the rubber bellows at the bottom where
they are secured with hose clips.
2. Tilt up and move both tilt cylinders all the
way up.
NOTE!
Adjustment must always take place with full hy-
draulic pressure in the tilt cylinders
.
3.
Loosen the three lock screws on the cylinder fit
-
ted to the platform, Image 35.
Image 33. The platform underhang (A) varies
according to platform type, and this should be
taken into account when fitting the upper seal.
A (mm)
70
81
Type
Vehicle floor level
Steel
Flat 40 mm
A
Max. 40 mm, Min. 38 mm
Image 34. Check the position in rela-
tion to the rear member of the vehicle
5. Test the lift by carefully raising it to the vehicle
floor level and tilting it to the vertical position.
Check the position in relation to the rear beam
and side posts of the vehicle. See Image 34.
Lock screws, 3
pcs.
Out
In
Image 35. Adjusting the tilt angle
Summary of Contents for ZDK 250 135
Page 2: ......
Page 65: ...ZDK 250 135 155 Registration 65 www zepro com...
