ZDK 250 135/155
34
Installation
www.zepro.com
4.9.1
Controller CD 1
1. Fit the controllers in the desired locations.
However, locate them such that the operator’s
working position is as safe as possible, and with
an adequate overview of the load, tail lift and their
working area.
2. The distance between the vehicle’s rear edge
and the centre of the controllers must be 300-
600 mm. The distance between the controllers
must be at least 260 mm. See Image 57.
3. Any additional controllers can be installed in an
optional location.
4. Run the controller cabling to the tail lift cable grom-
met. Connection is described later in section 6.
Image 57. Installing control-
ler CD 1 with two-handed grip.
Min. 260 mm.
300 - 600 mm.
Summary of Contents for ZDK 250 135
Page 2: ......
Page 65: ...ZDK 250 135 155 Registration 65 www zepro com...
