ZHD 2500-130/150
20
Installation
www.zepro.com
6.3
Control devices
If the vehicle is equipped with two-handed grip, the
operator must use both hands to operate the plat-
form. It also protects the operator from pinching and
crushing injuries.
1. Fit the control devices in the desired locations.
They must be positioned so that the operator is in
the safest possible location and has a clear view
of the load, the tail lift and the surrounding area.
2. The distance between the vehicle's rear edge and
centre of the control devices must be 400 mm ±
100 mm. The distance between the control devices
must be at least 250 mm. See illustration 23.
All cable inlets must be pointing downwards.
NOTE.
3.
The control device’s cable is connected to the
control card.
Image 18. Installing control
device with two-handed grip.
Min. 250 mm.
A control device must always be installed on the side
that is turned away from moving traffic. If a control
device is needed on the other side, a further control
device must be installed. Installation in any other way
increases the risk of personal injury.
m
WARNING!
Image 19. Installing control device
400mm ± 100mm
