ZHD 2500-130/150
28
Installation
www.zepro.com
6.12.1
Adjusting the tilt angle
Do not adjust the cylinders before they are fit
-
ted to the platform. The tilt cylinders are preset
from the factory.
NOTE.
1. Loosen the rubber bellows at the bottom where
they are secured with hose clips.
2. Tilt up and move both tilt cylinders all the way up.
Adjustment must always take place with full
hydraulic pressure in the tilt cylinders.
NOTE.
3.
Loosen the three lock screws on the cylinder fitted
to the platform. See Image 43.
5.
Test the lift by carefully raising it to the vehicle floor
level and tilting it to the vertical position. Check the
position in relation to the rear beam and side posts
of the vehicle. See Image 41.
Max. 40 mm, Min. 38 mm
Image 41. Check the position in rela-
tion to the rear beam of the vehicle
Image 42. The platform underhang (A) varies
according to platform type, and this should be
taken into account when fitting the upper seal.
A (mm)
70
81
Type
Vehicle
floor level
Steel
Flat 40 mm
A
Lock screws, 3 pcs.
Out
In
Image 43. Adjusting the tilt angle
