Markings and decals
37
www.zepro.com
ZHZ 500/600-850
Fig 48. Warning flags
Fig 49. CE marking
11.5 CE marking
The marking below represents the manufacturer’s
guarantee that the lift is designed and supplied in ac-
cordance with the requirements stipulated in the EC
Machinery Directive. This is the customer’s guaran-
tee of high quality and safety.
Fig 46. Danger area
Fig 47. Warning tape
11.6 Danger area
A “danger area” decal warns about the danger
zone between the platform and the rear edge of the
vehicle. The decal must be attached to the inside of
the vehicle body, close to where the manual control
device is installed.
11.7 Warning tape
The warning tape is ideally attached along the plat-
form’s edges to indicate the edges of the platform
in the lowered position. The location of the warning
tape often coincides with the contour marking, in
which case the warning tape can be omitted.
11.8
Warning flags
Attach warning flags as close as possible to the top
and edge of the platform, where there is no risk of
them coming loose when the platform is lowered to
the ground. Swage the tracks together to secure the
warning flags in place.
