EN
13
11 - USAGE OF ACCESSORIES
CAUTION!
Every time an accessory is changed or replaced, the main device has to
be disconnected.
The accessories heat up during use. Be careful when replacing or removing
them. Do not work with wet feet or hands.
11.1 EXTENSION TUBE (32)
Each accessory can be connected directly to flex tube (31) (picture K) or to
extension tube (32) (picture L).
11.2 TRIANGULAR BRUSH (33) AND RECTANGULAR BRUSH (36)
To use the triangular or rectangular brushes, the brush coupling needs to be
attached (37)
1. Keep the brush coupling (37) oriented downwards and inserted it into
brush (pictures M; O)
2. Place the coupling (37) in a working position while rotating upwards
(pictures N; Q)
3. Connect extension tube (32) or nozzle from flex tube (31) to brush coupling.
Press the spring button and insert end of extension tube or nozzle into
brush coupling until the spring bottom snaps into its correct
position.
REMOVING BRUSHES
1. Push the spring bottom on the flex tube nozzle (31) or extension tube (32)
and pull it out of the brush coupling (37)
2. Direct brush coupling (37) downwards and remove the brush from brush
coupling.
APPLYING PROTECTIVE CLOTHS
NOTE: Cotton cloths help protect the surfaces to be cleaned from
scratches. Dirty cloths can be machine washed.
WARNING!
Cotton cloths become hot during use.
Cloths can be changed only after device has been disconnected.
RECTANGULAR BRUSH (36) – FLOOR WIPER (44X32 CM) (35)
1. Place the protective cloth on a flat surface
2. Put the brush (36) in the centre of the cotton cloth (35).
3. Press the right clamp and insert cloth under the holder. (pictures R; Ra)
4. Release the clamp.
5. Repeat same procedure for left side.
