EN
10
1
7.1 VACUUMING - WET & DRY WITH WATER FILTER
Please only vacuum liquids such as water and spilled beverages. Always clean
afterwards according to instructions below.
WARNING! To vacuum up liquids, you do not have to fill the water tank
with clean water! If large amounts of water are to be vacuumed, you
should use medium speed and maximum speed for small amounts, never
minimum. The appliance can suck-up up to 1.2 litres of liquid. In excess
of this quantity, the safety float is enabled making a noise and the motor
noise becomes more acute. At this point, turn the vacuum function off
immediately and empty the water bucket.
Fill the water tank as described in chapter 6. Carry on with your cleaning
operations, choosing the best accessory for the job, see chapter 8.
To have maximum vacuum power,select vacuum power on the grip (Pict.1). If you
are vacuuming dust or other kinds of dirt, replace the tank water frequently.
If you only want to vacuum dust, refill the water tank in any case as described
in chapter 6.
Vacuuming
Follow the instructions above and then choose the accessory best indicated for
what it is you want to do. Turn on and choose the desired speed. Use the lowest
speed for delicate materials and medium or high speed for most other jobs, just
as required.
Vacuuming liquids only
If you want to vacuum liquids, such as spilled water, no need to add water first,
but you can start vacuuming directly. For best results do the following:
Medium speed - large amounts of localised liquids (e.g. a siphon).
High speed - small amounts of liquids.
7 - OPERATION
7.2 STEAM CLEANING & DISINFECTION
As the right pressure is reached, the flashing orange light becomes steady, and
steam is ready to be delivered. Now insert the desired cleaning accessory directly
into the hose grip handle or with one or more extension tubes in between. To
deliver steam, just pull the steam power button on the handle (Pict. 1). In order
to get the best steam output, start with the steam regulator at minimum (-),
then slowly turn up (t) until you reach the perfect steam-pressure for
your work. For further instructions see chapter 8 USAGE OF ACCESSORIES
7.3 STEAM CLEANING & VACUUMING AT THE SAME TIME
When operating the two functions together it is important that you FIRST heat
up the boiler and do some steam cleaning in order to heat up the Flex Tube,
the Extension tubes and the accessory you are using. Only when the device is
fully heated up should the vacuum-function be added to the steam function.
steam power button
steam safety lock
speed button
