5
R/Z* (faucet spout)
If the inlet water pressure is different than the one set at the factory, it is possible to regulate the spout and modify
the height of the jet.
Regulator underneath the button: unscrew the nut (G), take the button off (P) and adjust the screw slowly (V)
Lateral regulator: adjust the screw slowly (V).
ELECTRICAL CONNECTION
This product can be supplied with detachable power cord or with a no detachable power cord.
If the detachable power cord is damaged
, it must be replaced with a cable available
from the
manufacturer
or its technical assistance service
If the not detachable power cord is damaged
, it must be replaced
by the
manufacturer, its service agent or
similarly qualified persons in order to avoid hazard
Make sure that the power supply to the appliance is the same as the voltage indicated on the label on the side of the
appliance.
The appliance must be grounded in compliance with applicable standards and laws. In case of
malfunctioning, grounding reduces the risk of electrical shocks.
Connect the appliance cable to a double-pole switch with a minimum of at least 3 mm distance between the contacts,
or using a plug which must still be accessible after installation.
(080)
USING THE PRODUCT FOR THE FIRST TIME
When you first use the product, in order to remove any air inside the system, it is recommended to:
a.
Open the water valve and wait a few minutes to make sure there are no water leakage.
If the system includes electrical controls, connect the product to the power supply to enable the delivery keys.
b.
Press the cold water button to let the air out. Release the button only when the water starts coming out.
c.
Drain at least 30 litres of cold water and , if the system includes it, a few litres of the ambient water.
d.
When you first install the product, you will have to wait a few hours before dispensing cold water.
For products with the HPDC® – High Performance Direct Chill – system, waiting times are a few minutes.
(102)
