Zernike FlashGRILL Evolution, Use And Maintenance Manual

- 15 -

Ed.1  05/2017

EN

8.1 - WARNINGS

 - Do not use cleaners containing abrasive powders, thinners, solvents or deter-

gents.

 - Do not use water jet or high pressure cleaners.

 - Use cleaning products suitable for steel. Dry all surfaces at the end of opera-

tion.

8.2 - CLEANING OF COOKING SURFACES (daily)

The cleaning of these surfaces must be daily.

It is essential to thoroughly clean the surfaces in direct contact with food to promptly to 

eliminate fouling, with appropriate cleaning products.

8.3 - TOUCH SCREEN DISPLAY CLEANING

The touch screen is made of glass, it can be cleaned with any non-abrasive glass cleaner.

8.4 - CLEANING OF FAT COLLECTION TRAY

The tray must be removed, emptied and washed with a soft brush and warm water contain-

ing a degreasing agent; rinse with warm water and wipe dry with a clean cloth.

The tray can also be put in the dishwasher.

8.5 - PERIODS OF INACTIVITY

During periods of inactivity observe the following precautions:

 -

Turn off the main switches upstream of the equipment

 - Rub all stainless steel surfaces with a cloth soaked in mineral oil to create a protective 

layer

 - Ventilate the premises periodically

 - Subject the device to inspection before using it.

8.0 - CLEANING

FlashGrill can be cleaned by the end user also during the cooking process, in order to 

wash it quickly as well as to interchange different courses. To clean the fry top pour some 

hot / warm water on the hob while it is on, and use the supplied cleaning scraper to remove 

scale and slide the water and the cooking residues toward the collection tank.

After this cleaning operation, taking just a few seconds, cooking can go on without interrup-

tion, in fact the temperature doesn’t change nor decrease, so it is not necessary to stop the 

service. 

After use, when the equipment is turned off, wait for about 30 minutes that the 

notice “HOT” disappears and when the fry top is tepid, spray the FlashClean on 

the cooking surface, let it act for about 5 minutes and then rinse it with plenty of 

water, finally dry the plate.