Error Messages
Memory Problems
The memory Page displays may show one of the
following messages if a memory error is detected
when the desk is turned on.
Mode switch in any position.
Super User set up options have been
corrupted
The output Strobe / Full Level channel
memory has been corrupted
The DMX patch memory has been
corrupted
Lost Pattern - The sequence memories
have been corrupted
The MIDI lighting control data has been
corrupted
All these problems are likely to be transitory.
They may require a Super User Clear Memory
and/or Reset operation and some
reprogramming. Always keep a copy of important
shows on a Memory Card.
Mode switch in MIDI Setup In / Slave
— Display —
Page Step No.
Active Sensing loss of MIDI data -
check if the cable is unplugged
or open circuit
Illegal System Exclusive
command received
/p25/4
Hardware Problems
The Lightmaster XL will display ‘CR’ (crash) in
the Page display if the hardware is not operating
correctly. There are two types of crashes: those
that will allow some desk operations to proceed
despite the fault and those that prevent the desk
working completely.
Faults that allow desk operations to continue:
— Display —
Page Step No.
Chaser frame memory recovery
failed (Faulty Eprom )
Analogue input ICs not reading
0 volt line correctly
Analogue input ICs not reading
‘Vref’ correctly
Faults that prevent the desk working completely:
DMX transmission has failed
DMX transmitted data not being
transmitted correctly
DMX transmitted data not being
transmitted correctly
Eprom checksum not correct
(Faulty Eprom)
RAM testing has failed
(Faulty RAM)
Mode switch in faulty position
Hardware Problems (Continued)
When a hardware problem is detected the desk
will stop but the outputs will stay at their previous
levels.
To continue after a hardware problem is
detected, press the Page +, Page - or Go buttons.
If the problem persists the desk will again be
halted until the hardware is repaired.
Memory Card Errors
Insert Card
Battery Low
Not Formatted
Not a Lightmaster XL Card
No Data Saved
Corrupt Card
Protected
Not Verified
Card Error
Card Error
Card Send Error
Card Receive Error
Card Addressing Error
Error Messages
7359500/p25/4
Page 25
Summary of Contents for Lightmaster XL
Page 1: ...Lightmaster XL Manual...
Page 29: ......
