Quick Start Tutorial
Page 28
ORB Operating Manual – Issue 1.0
Group Window
The Group Window is displayed by default in the bottom right hand
corner of Monitor 2. This allows you to click and select any of the
programmed groups automatically.
Figure 18 – Group Window (bottom right)
Submasters
The ORB has upto 30 submasters, which can be paged 20 times to
give upto 600 programmable locations for scenes stored onto
faders. Submasters can be accessed either by altering the mode of
the playbacks, or by using another DMX enabled desk and using
DMX-In.
Recording Submasters
Before recording a submaster, ensure that you have the number of
submasters per page defined as you require it. This setting is found
in Desk Setup / Inputs.
To record a submaster, first set up the fixture outputs as required,
ensuring that the correct parameters are tagged. To record the data
to a submaster, enter the following command:
RECORD SUB n ENTER
To record to a specific page, enter:
RECORD SUB m / n ENTER
You can view programmed submasters in the Submasters window,
by holding SHIFT and pressing SUB.
Replaying Submasters
In this quick start guide we will just look at using DMX In to replay
submasters. For details of using Playbacks as Submasters, see the
Submasters chapter of the full manual (page 104).
In the Desk Setup / Inputs screen ensure you have defined a DMX-
In address for each of the programmed submasters. You can then
use the faders on your DMX-In desk to control the submasters.
Raising the submaster will replay the scene, and lowering it will
remove it from the outputs.
Summary of Contents for ORB
Page 1: ...ORB OPERATING MANUAL...
