Setup
Page 40
ORB Operating Manual – Issue 1.0
Press the [Next] button to select the fixture Mode. It is important
that the mode set here matches the mode set on the fixture itself –
if in doubt, consult the fixture operating manual for full details.
Figure 30 – Patch Wizard (Step 3 – Mode Selection)
Once the Mode has been selected, press the [Next] button to move
on and enter the DMX address for the fixture. If you have not yet
set this on the fixtures themselves, press the [Next Address] button
and the desk will calculate a DMX address for you based on the
existing patch information.
It is important here to ensure that the DMX universe is correctly
selected.
Figure 31 – Patch Wizard (Step 4 – DMX Address entry)
Once the address is configured, press the [Next] button and enter
the quantity of the fixture required. The monitor screen will tell you
the number of fixtures and control channels remaining within its
limits, to ensure you do not exceed these limits.
Summary of Contents for ORB
Page 1: ...ORB OPERATING MANUAL...
