Live Editing
Modifing Brightness Chase
Attributes
1
To modify Brightness chase
attributes (chase speed, direction,
attack, etc) while running on a
submaster, press the MODIFY
button then press the FLASH
button for the appropriate
submaster and then release the
MODIFY button.
2
Use the Wheeel to modify the
chaser speed and the attribute
buttons to change other attributes.
3
Once adjusted press the MODIFY
button to remove the pop up
screen, from the monitor.
Overriding a Transition Time
While in Run Mode, the wheel display
shows Col Time, Beam Time, and Pos
Time over three of the wheels. These
wheels allow transitions to be speeded
up or slowed down, made instant or
stopped - depending on how far the
wheel was moved and in which
direction.
Transitions generated using the
Attribute Memory Selection buttons are
overridable.
Transitions in CueLine
®
are not
affected.
The transition must be happening
before moving the wheel will have any
effect. The affect is permanent. Any
future transitions will occur at the
programmed times.
NOTE
Crossfade Time
The crossfade time has been changed
temporarily. A permanent change can only
be made in PROGRAM mode, see the
section on Editing a Brightness Memory on
page 3-18.
/p6-13/3
Modifying Position Live
Where available
1
To modify the Position parameters
of a fixture whilst in RUN, press
the MODIFY button followed by the
POSITION button.
2
Use the channel flash buttons to
select the fixtures to be modified.
Those available to be modified
have a yellow light in the button,
which turns red once selected.
3
Use the wheels indicated in the
Wheel Display or the mouse to
modify the current X and Y position
for the selected fixtures.
4
Press the MODIFY button again to
revert to normal.
Activating Topset
Ensure that the keyswitch is in RUN
MODE and in TWO PRESET and not
WIDE, as indicated by the TWO
PRESET light adjacent to the Key
Switch. (If the red WIDE light is on,
follow the procedure outlined in the
section on Desk Set-Up on page 5-6 to
revert to normal, non WIDE.)
1
Bring the MASTER A fader to zero.
2
Raise all the PRESET A faders to
full. Press and hold the TOPSET
button until the red light in the
button comes on.
3
To show the effect of TOPSET,
use a submaster to bring up a
memory live on the output.
4
Pick a channel that is on, as
indicated by the green channel
output light.
5
Move PRESET A to zero.
The luminaire is now off. It is not
possible to output any light on that
channel unless PRESET A is
moved.
6
Live Editing
7364000/p6-13/3
6 - 13
Summary of Contents for SIRIUS 500
