background image

4

Author: Rudi          Version: 2.1          Revision: 1.2          Revision Date: June 2019

GAS CONNECTION:

The  appliance  inlet  is  to  the  8mm  plain  straight  tube,  allowing  connection  by

means  of  a  gas-tight  compression  fitting  to  comply  with  both  EC  and  local
regulations.  The  freezer  is  suitable  for  connection to  butane/propane  mixtures
(LPG) at 2.8-3.0 kPa and to propane at 3.7 kPa. Means must be provided to turn
off the gas supply. If the supply is common to other appliances a separate tap must
be fitted for the freezer line.

WARNING

:

ENSURE  THAT  THE  GAS  SUPPLY HOSE  IS  NOT  IN

CONTACT WITH OR NEAR THE BURNER BOX

GAS-PRESSURE REGULATOR

This appliance requires an operating pressure of 2.8 kPa at the appliance. A
suitable LPG regulator that complies with the requirements of SANS 1237
must be installed.

OPERATING INSTRUCTIONS FOR FREEZER

It is important to read through these instructions carefully before beginning to use
this appliance.
Retain these instructions for future reference.

LP. GAS OPERATION:

After  initial  installation,  after  changing  gas  cylinder,  after  servicing,  etc.,  the  gas
pipes may contain some air, which should be allowed to escape by briefly pressing
on the safety valve knob (A).  This will ensure that the flame lights quickly.
Do not press knob A for more than 15 seconds – see Users note.

BURN-BACK (FIRE IN BURNER TUBE OR CHAMBER)
(REFER PAGE 4 – TO START GAS OPERATION)

In the event of a burn-back, where the flame burns back to the jet, immediately turn
off the gas supply at the control valve on the gas bottle or gas supply . After
ensuring the flame is extinguished, re-open and re-light the appliance in the normal
manner. Should the appliance again burn back, close the control valve and call a
service technician. Do not use the appliance again until the service technician has
declared that it is safe to do so.

WARNING

This appliance consumes  air  (oxygen).  Provide  ample  ventilation  especially  when
sleeping. To  avoid  endangering your  life  do  not  use  this  freezer  in  unventilated
structures.  Provide additional ventilation for any additional fuel burning appliances
and  additional  occupants.    Always  ensure  nothing  is  covering  or  blocking  the
flue(chimney).

FOR YOUR SAFETY

If you smell gas:

1.

Turn off gas supply at bottle.

2.

Extinguish all naked flames

3.

Do not operate any electrical appliances.

4.

Ventilate the area.

Summary of Contents for GF230IP













Reviews: