5-13
A
A
A
B
Headlamp Alignment
The headlamp should be checked for correct
alignment periodically. It must be aligned any time the
sag is adjusted because this will affect the headlamp
alignment. Before the headlamp can be aligned, the
sag and tire pressure must be correctly adjusted. The
headlamp can be adjusted horizontally and vertically. If
the horizontal adjustment is off, the beam will point
too far off to one side. If the vertical adjustment is off,
it will cause the beam to point too close to or too far
ahead of the motorcycle. With the headlamp on the
low beam position, the motorcycle perpendicular to
the ground, and the operator sitting on the motorcycle,
verify the beam alignment.
To adjust the headlamp horizontally, turn screw (B)
until the correct beam alignment is achieved.
To adjust the headlamp vertically, loosen the housing
screws (A). Move the housing up or down until the
correct beam alignment is achieved. Tighten the
screws. See Bolt Torque Table on page 5-2.
Summary of Contents for DS 2010
