14 • Installation & Operation
INSTALLATION & OPERATION
Night Curtains
Cases ordered with night curtains will have factory-installed mounting brackets. A retrofit kit must be ordered from Zero Zone to install onto a
case that was not ordered with night curtains.
Some night curtains pull down and lock into position like roller window blinds. Other night curtains use a magnet and attach to the metal
kickplate. If the night curtain has a magnet, orientate the night curtain so the magnet can attach to the case.
Tip the night curtain forward into the mounting bracket and twist it until you hear a click as the brackets engage (
the night curtain can be pulled down (
under Shelf Lights
).
2. Attach the under shelf light to the shelf using the two magnets that are factory-installed to the light stick.
3. After installing the shelf, plug the wire into the nearest duct pocket under the shelf (
).
4. Bundle harness wire and place into magnetic clip. Mount magnetic clip on the side of the shelf bracket.
FIGURE 24: Install Night Curtain into the Brackets
FIGURE 25: Night Curtain Pulled Down
FIGURE 26: Install Light Under the Shelf
FIGURE 27: Plug Into the Duct Pocket
