zero
HOME AUTOMATION
Z02 - SWING GATE
PG10
01 • Remove the plastic cap from the rear
end
Information engraved on the unlock shaft
D=Unlock || B=Lock
• Clean stainless steel arm
• With a cloth soaked in lubricant spray,
wipe any residue that accumulates on the
operator’s stainless steel arm.
• Apply a small amount of spray lubricant
on the arm and using a dry cloth remove
the excess, leaving a homogeneous layer of
lubricant over the arm.
• Lubricate pins
• Remove front and rear caps
• Place a small amount of lubricant on the
holes that contains support pins.
• Install caps on the respective holders.
04. MAINTENANCE
Check motor supports: Make sure that supports remain well fixed on the pillars and
gate to ensure proper functioning of the equipment.
These maintenance measures must be applied every year in order to insure proper
functioning of the automated system.
MANUAL RELEASE
To open manually the gate in case of electric power failure or in case of damage, follow the
below steps:
