Setup and Calibration
Linking
Keep the distance between the Air Set and the Ground Set between 1 and 2 meters. Connect both
Sets to power.
Press the Link Buttons on the Air and the Ground Sets for 3 seconds until the C-LED indicators
turn flashing green. Linking begins.
Linking is successul if the C-LED indicators on the Air and Ground Sets turn green.
ŀ
喆
The Ground Set is linked to the Air set by default. Linking is required when a new Ground Set is used.
After linking an Air Set to a new Ground Set, the Air Set's previous linking to another Ground Set is automatically abolished.
Ł
ł
Signal lights
Green
Flashing Green
Red
Flashing Red
ŀ
C-LED Indicator
V-LED Indicator
Ł
Pattern
Status
Operation
Pattern
Status
Operation
Linking.
The Link Button has been pressed. The Air Set is
in the process of linking to the Ground Set.
Communicating
Wait for the linked Sets to communicate.
Linked.
No futher operation is needed.
Initializing.
Wait for the device to finish initializing.
Functioning normally.
Corresponding indicators on the Air Set and on the Ground Set specify the same status.
喆
LINK
C-LED
Link Button
Control Indicator
Linking
Linked