ZeroWater ZJ-004S, Owner'S Manual

6

7

5.

Install the filter adapter to the

upper chamber by threading it
clockwise until you feel a tight
and secure fit.

4.

One

 plastic o-ring 

is 

included with

your device. Place 

the 

o-ring around

the outside of the top

of the filter

adapter. The top filter

adapter is the

one which threads

into the top

reservoir of the device.

6.

Remove filter cartridges from

packaging. Tightly thread the cartridges
into the holes on the bottom side of the
filter adapter to obtain a complete seal
with the blue O-ring.

7.

Place the upper chamber (with

attached filter cartridges) on top of
the lower chamber. Be sure that the
lower chamber divider ring is tightly
affixed around the lower chamber.

8.

Place the lid on top

of the upper chamber.

FILLING THE JUG WITH TAP WATER

1.

Remove lid.

2.

Slowly fill the upper reservoir with cold tap water.

Be careful not to dump water too quickly into the upper
chamber when the lower chamber is empty as it may tip
and spill.

3.

Allow water to pass from the upper chamber through the

filters into the lower chamber. Water will be ready to drink in
several minutes.

4.

Test the water using the TDS meter to confirm a “000”

reading. If the meter doesn’t read “000”, empty all the water
from the unit, check all connections and seal, then repeat
steps 2 and 3.

5.

Do not over fill. The first time you fill your Filter Jug it

will take extra water to fill the cooler reservoir. When water
in the lower chamber reaches the line marked “MAXIMUM
WATER LEVEL”, do not put any more water in the upper
chamber, as it may leak. The upper chamber is not
designed to be a storage reservoir.

 Bottom of Filter Adapter