Zeta Alarm Systems SIMPLICITY MICRO, Instruction Manual

ADDRESSABLE

FIRE ALARM PANEL

ci

i

m

p

l

i

S

y

t

Micro

INSTRUCTION MANUAL: 32 Device,4 Zone Addressable Fire Alarm Panel  

Approved Document No: GLT.MAN-129

PAGE 18

Issue : 1.0        Author: NRPJ      Date: 11/04/2008

Alarm Condition & Resetting an alarm 
 

The Simplicity Micro signals an alarm by the following:- 
 
Turn on the General Fire LED 
Turn on the Zonal Fire Indicator 
Display the address & description of the device in alarm 
Turn on internal buzzer 
Start any sounders connected to the loop 
Activate the fire relay 
 

What to do in the event of a fire. 

1.  Follow the building evacuation procedure, and check that everyone has 

left the building safely. 

2.  The building fire officer or responsible person should CAREFULLY 

enter the building, and locate the area of the alarm from the fire alarm 
panel. 

3.  Investigate to determine the cause of the alarm. The detector that 

signalled alarm will be displayed on the screen, and it will have its RED 
ALARM LED on. 

4.  If a small fire is found, a suitably trained person could tackle this with a 

suitable fire extinguisher. 

5.  If a larger fire is found, leave the building immediately, and contact the 

fire brigade. 

6.  If no fire is found, make a note of the detector that signalled fire, and 

look for anything nearby that could be the cause of the activation, eg 
cooking, or use of a hot air gun etc. 

7.  Record findings in the fire alarm log book. 

Resetting from an alarm condition 

 
After the relevant action has been taken, the Simplicity Micro fire alarm panel can be reset by 
the following:- 
 

1 

Press Stop/Start sounder button. (if the panel prompts for access code, type in 
123, then press Start/Stop Sounder again)This will silence the external sounders. 

2 

Press Silence Fault Tone button. This will silence the panel`s internal buzzer. 

3 

Press the Reset button. This will return the panel to it`s normal condition. 

 
If the panel goes straight back into alarm, then the cause of the alarm has not been 
cleared. This could be a detector still exposed to smoke, or a call point still in the active 
position. Press Buttons Stop/Start Sounder button & Silence tone button on the panel, 
then investigate for a call point, or detector that still has it`s RED ALARM LED on. Reset 
the call point, or clear the smoke. If the problem persists, contact an engineer.