Written by:.JBJ
Checked by: RP
Document Number: Premier MX User 1.doc
Page 8 of 19
14/12/06
o
The general Disablement LED will light.
•
To enable the sounders:
o
Press the Enable button to enable the sounders.
o
The Sounder Fault/Disabled LED will change to the “Off-flash”
indication while the cursor is on it, changing to off if the cursor is
moved on.
o
The general Disablement LED will be cleared if no other disablements
are present.
•
To quit the disable/enable mode:
o
To exit the Select Mode, press the Select On/Off button.
o
The Select On LED will clear.
o
The cursor indication will clear.
o
Set the Access Controls Keyswitch back to position “0” to lock the
controls.
4.3.
To Disable/Enable the Fire Routing Output.
•
To Access disable/enable mode:
o
Turn the Access Controls Keyswitch on the panel door to position “1”.
o
Press the Select On/Off button to enter the Select Mode:
o
The Select On LED will light.
o
The cursor indication will pulse the yellow Zone 1 fault/disabled/test
LED.
•
To select the Fire Routing Output:
o
Use the Select
↑
button to move the pulsed cursor indication up
through the fault LEDs until it pulses the Fire Routing Fault/Disabled
LED. [The Select
↓
button moves the cursor down].
•
To disable the Fire Routing Output:
o
Press the Disable button to disable the Fire Routing Output.
o
The Fire Routing Fault/Disabled LED will change to the “On-flash”
indication while the cursor is on it, changing to steady if the cursor is
moved.
o
The general Disablement LED will light.
•
To enable the Fire Routing Output:
o
Press the Enable button to enable the Fire Routing Output.
o
The Fire Routing Fault/Disabled LED will change to the “Off-flash”
indication while the cursor is on it, changing to off if the cursor is
moved on.
o
The general Disablement LED will be cleared if no other disablements
are present.
•
To quit the disable/enable mode:
o
To exit the Select Mode, press the Select On/Off button.
o
The Select On LED will clear.
o
The cursor indication will clear.
o
Set the Access Controls Keyswitch back to position “0” to lock the
controls.
4.4.
To Disable/Enable the Fault Routing Output.
•
To Access disable/enable mode:
o
Turn the Access Controls Keyswitch on the panel door to position “1”.
