29
RS232
C
ONSOLE
U
SER
C
OMMANDS
Command Summary – General Use
Command
Description
Password
hello
Starts the RS232 Diagnostics & Command Console
N/A
letmein
User password
N/A
setrs232
Sets the Serial Interface to RS232 {3}
Requires User Password
setrs485
Sets the Serial Interface to RS485
Requires User Password
baud2400
Set the Baud Rate to 2400 {3}
Requires User Password
baud4800
Set the Baud Rate to 4800 {3}
Requires User Password
baud9600
Set the Baud Rate to 9600 {3}
Requires User Password
baud19200
Set the Baud Rate to 19200 {3}
Requires User Password
baud38400
Set the Baud Rate to 38400 {3}
Requires User Password
baud57600
Set the Baud Rate to 57600 {3}
Requires User Password
baud115200
Set the Baud Rate to 115200 {3}
Requires User Password
deepsleepdisable
Disable Deep Sleep mode
Requires User Password
deepsleepenable
Enable Deep Sleep mode
Requires User Password
disablelightsensor
Disable the Light Sensor {2}
Requires User Password
dwelltime
Input a dwell time
Requires User Password
enablelightsensor
Enable the Light Sensor {2}
Requires User Password
normal
Normal Display i.e. No Tests
N/A
powercycle
Emulates a complete restart of the system
Requires User Password
reset
Resets calibration values and configuration options to
factory default
Requires User Password
setcount
Set 4 digit counter display on display 1 {4}
Requires User Password
set8rate
Set 8 Digit Volume and Flow Meter {2}
Requires User Password
setsas
Set 4 digit strain gauge system on display 1 {4}
Requires User Password
Notes:
{1} Applies to 2 digit display variant only.
{2} Applies to 4 digit and dual 4 digit display variants only.
{3} Requires a power cycle, physical or by command after command use
{4} Applies to 4 digit display variants only.
