Cab Steps Lights (only if equipped with the light controller)
The cab steps lights are located in the cab roof above the left cab door.
The cab steps lights automatically switch on, only in the night mode, for one to two minutes always when the
battery disconnector is turned on or the ignition key is moved from position I to position 0.
When the ignition key is moved from position 0 to position I, the step lights switch off even before the time
has elapsed.
Aggregation opening
If the cabin step illumination is on, do not
disconnect the battery by the battery disconnect.
Disconnect the battery only after the cabin steps
illumination is off.
FHD20S5N018
Aggregation opening serves for cabelling or Bowden
control of aggregated tools placement.
Pull to protrude the part of sealing of rear window in
upward direction. Put the aggregated tool control through
the originated hole.
Insert cabelling or Bowden controls to the holes of
passage of aggregation opening. Return the sealing of the
rear window to its original position by exercising pressure.
C18N054
ACQUAINTANCE WITH THE TRACTOR
37
Summary of Contents for FORTERRA HSX 120
