Switching on Work Lights and Beacons
FHD20S5N015
Description of Work Lights and Beacon Control Panel
1 - Work Light Memory and FNR Automatic Control Switch
2 - Work Light Control Switch on the Front Turn Signal Lights Brackets (depending on equipment)
3 - Control Switch of Interior Front Work Lights on the Cab Roof
4 - Control Switch of Exterior Front Work Lights on the Cab Roof
5 - Beacon / Beacons Control Switch
6 - Control Switch of Interior Rear Work Lights on the Cab Roof
7 - Control Switch of Exterior Rear Work Lights on the Cab Roof
8 - Control Switch of Work Lights on the Rear Cab Columns
9 - Control Switch of Work Lights in the Cab Grill
The number of work lights may differ from the picture depending on the tractor equipment.
Switching on Work Lights and Beacon Panel
The panel turns on automatically when the battery disconnector is turned on; if no work light or beacons are
on, the panel turns off automatically after approx. 150 s.
If there is no key in the key switch or the key is in position 0, the panel will turn on when any button is
pressed. If no work light or beacons are on, the panel turns off automatically after a certain period of time.
If the ignition key is in position I in the key switch, the panel is always on when the ignition key is moved to
position 0, if no work light or beacons are on, the panel turns off automatically after a certain period of time
(approx. 2 min).
If the user activates the position lights, the panel switches on / wakes up (only at the first impulse). If no work
light or beacons are on, the panel turns off automatically after approx. 30 seconds.
Work Lights Control - Manual
The work lights are switched on using the corresponding buttons (2, 3, 4, 6, 7, 8, and 9) on the panel.
The buttons of work light installed are dimly backlit in green (orientation backlight); if the relevant work lights
are switched on by briefly pressing the button, the button illumination changes to dark green (functional
backlight).
When the work lights are switched off by pressing the corresponding button again, the backlight of this button
changes to light green (orientation backlight).
If a button is not backlit (orientation backlight), the tractor is not equipped with the relevant work lights.
If a button is backlit in red, there is a fault in the relevant work lights circuit (short circuit, lights open circuit, or
button malfunction).
If a light is active and on and the key is switched off, all lights will go out automatically after 5 minutes after
the key has been switched off.
ACQUAINTANCE WITH THE TRACTOR
43
Summary of Contents for FORTERRA HSX 120
