Beacons Control
To turn on the beacons, press button (5) on the work light and beacon control panel.
The beacons button is backlit in light green (orientation backlight); if the beacons are switched on by briefly
pressing the button, the backlight of the button changes to dark orange (functional backlight).
When the beacons are switched off by pressing the corresponding button again, the backlight of this button
changes to light green (orientation backlight).
If the button is not backlit (orientation backlight), the tractor is not equipped with beacons.
If the button is backlit in red, there is a fault in the beacons circuit.
The backlight intensity of the buttons is automatically controlled depending on the ambient
light conditions.
Reduce the use of work lights when the engine is not running, the battery might discharge.
If the work lights are activated and the key is not switched on at the same time, the lights
switch off automatically after about 10 minutes.
If there is an alternator defect, the work lights may be deactivated automatically.
When the engine is being started, the headlights may be deactivated temporarily.
If the work lights are left switched on after the key is switched off, they will switch off
automatically after 5 minutes.
Tractor Cab Lighting Control
The interior lighting is located on the cab ceiling. It can be manually switched on and off using the built-in
button (manual activation does not affect the automatic function).
The interior lights are activated automatically with a delay after the disconnector has been switched on (only
at dusk and at night, night mode) for a maximum time of 1 minute.
When the key is switched off, the lights are activated for 2 minutes (only at dusk and night, night mode).
If FNR automatics is active and Neutral is selected on the reverse shift lever, the lights remain active as long
as Neutral is selected.
If the lights are active, they switch off automatically when the ignition key is moved from position 0 to position
l.
Steps Lights Control
Cab Steps Lighting The cab steps lights are located in the cab roof above the cab door.
The lights are activated automatically for 1 minute after the disconnector has been switched on (only at dusk
and at night, night mode).
When the ignition key is moved from position 0 to position I, the step lights switch off even before the time
has elapsed.
When the key in the key switch is moved from position 1 to position 0, the step lights are activated for
2 minutes.
Do not disconnect the battery with the battery disconnector, while the cab steps light are on.
Disconnect the battery only after the step lights switch off.
Day / Night Mode
The day / night mode switches according to the photosensor (located between buttons 1 and 3) according to
the current light condition.
The day mode results in switching off the white backlighting of the tractor outline on the control panel and
stronger backlighting of the buttons in the off and on states.
The night mode results in switching on the white backlighting of the tractor outline on the control panel and
dimming the backlighting of the buttons in the off and on states.
ACQUAINTANCE WITH THE TRACTOR
44
Summary of Contents for FORTERRA HSX 120
