Programming
80
Windows 95, 98, ME, or XP Professional PC as long as the serial port settings are set to:
9600, N, 8, 1, no flow control.
Firmware Compatibility
Each version of CPS and CPSW is designed to work with a specific firmware version or
range of firmware versions. It is best to use the version of CPSW that was delivered with
your system or your last firmware upgrade. If you need a replacement copy of CPSW,
contact Zetron technical support. They can assist you with acquiring the correct
programming software for your specific firmware.
• CPS is supported for firmware versions up to 1.80 only.
• CPSW is supported for firmware versions 1.80 and newer.
Installation
Installation
To install CPSW, follow the instructions provided with it (
CPSW Installation Notes
, P/N
011-0795).
Uninstallation
♦
To uninstall CPSW
CPSW uses the standard Windows procedure for uninstallation.
1. From the Windows Control Panel, double-click
Add/Remove Programs
.
2. In the alphabetical list of installed programs, find and click
Zetron CPSW
to
select it.
3. With
Zetron CPSW
selected, click
Remove
(located on the same highlighted
line).
4. Proceed through the uninstallation wizard.
Tip
This chapter is for CPSW only. CPS DOS users can obtain the CPS
manual (025-9229
Model 4010 Programming
or by directly downloading from the Zetron reseller website. See
http://www.zetron.com
.
Note
The Microsoft .NET Framework can also be uninstalled using the
same method, but this is not recommended because other
applications may rely on .NET.