MZX Fire detection system
602SB
Fixing instructions Doc. version 5.0
3/6
Installation to a Flat
Surface or Electrical
Backbox
To install a sounder base, proceed as follows:
1 Feed the detection circuit wiring through the
mounting flange cable entry.
2 Secure the mounting flange to either an elec-
trical backbox or a flat surface as required.
3 Feed the detection circuit wiring through the
sounder base cable entry, then clip the
sounder base to the mounting flange.
4 Wire the sounder base as shown in Fig. 2
ensuring correct polarity.
Fig. 3: 602SB Sounder Base
Tone selection switches
Volume adjuster (clockwise to increase)
Volume trimmer tool
CAUTION
Do not fill the sound gap between the
mounting flange and the sounder base.
LPCB approval
For LPCB approval, detectors and caps
must be locked into the sounder base
using a locking device (Factory fitted).
Ensure that the locking device is in place
before fitting a detector or cap. See Fig.
5.
