2
PREPARING THE ZEUS ICEBORN
TM
Slowly fill the surrounding area of the heat
exchanger tube in the ice chamber with water. The
water should not exceed the protruding water level
indicators inside the ice chamber. When placed on a
flat surface, the water level indicators should be
visible above the water, by a few millimeters. If the
indicators are below the water, the water level is too
high and the excess water should be removed. Once
filled correctly, tightly lock the lid on the ice
chamber by rotating it clockwise until it falls into
place. Next, place the unit into the freezer overnight.
It can be kept in the freezer to be ready for use when
desired.
Notes:
-Make sure there is no water inside the heat
exchanger tubes, as the water will freeze and block
the vapor pathway.
-Make sure the water level does not exceed the
water level indicators, as the excess water may
damage the device after freezing.
-The lid should be locked onto the ice chamber for
the freezing process at all times and the device
should be placed on a flat and safe surface in the
freezer.
-When the ice chamber is left for longer periods in
the freezer, some condensed ice might block the
exit whip connector. If this happens, push the ice
down with little force with a small tool that can pass
through the opening.
Water level indicators
are above the water level.
Water level indicators
are below the water level.
Summary of Contents for Iceborn
Page 1: ......
