IMPORTANT NOTE:
In the event that any of these conditions can not be met (for
example certain laptop configurations, co- location with another transmitter, or use of a
different antenna), then the FCC authorization is no longer considered valid and the FCC
ID can not be used on the final product. In these circumstances, the OEM integrator will
be responsible for re-evaluating the end product (including the transmitter) and obtaining
a separate FCC authorization.
Suggested End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may
be installed such that 20 cm may be maintained between the antenna and users (for
example access points, routers, wireless ASDL modems, and similar equipment).
The final end product must be labeled in a visible area with the following:
"Contains TX Module FCC ID: Q5L-ZRC-20 ".
RF Exposure Statements That Must be Included in the Final Devices Users
Manual
The users manual for end users must include the following information in a
prominent location "
IMPORTANT NOTE
: To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter. This device
is approved for fixed or mobile applications. Portable conditions can NOT be allowed
due to the RF exposure compliance requirements."
Additional Information to OEM Integrators
The end user should NOT be provided any instructions on how to remove or install
the modular TX device.
NOTE: ANY CHANGES OR MODIFICATION NOT EXPRESSLY
APPROVED BY THE MANUFACTURER COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
