Hardware installation
9
2.3 Preparing the book cradle
Before installing the scanner at its final destination, you should prepare the book cradle.
Plug in the air hose [17] and power cable [18] first. The access is easier if the book cradle
is not installed in the scanner base yet. Use the power cable with the male and female
connector.
Fig. 11
2.4 Installing the scanner base
When you install the OS11000 at its final destination you should respect the following
points:
•
You need an even floor
•
The room should be as clean as possible, avoid dusty or humid environment
•
The scanner should not be installed directly below ceiling lights or close to windows to
avoid light reflexes on the glass plate
•
You should install the scanner back side at least 1,5m (5ft.) away from walls. If this is
not possible you need at least this space on the front side.
Put the scanner base to the point where it should finally stand. Turn the adjustment screws
on the base [19] to a level of 45 mm above the floor (Fig. 13). You will have to do a fine
adjustment at the adjustment nut [20] afterwards, so do not lock yet the counter nuts [21].
18
17
Summary of Contents for OS 11000 Hybrid Color
