9.
Put shim with e. g. s = 2.80 mm onto the
bearing bolt.
Fig. 164
10. Rotate intermediate gear several times and
use 5870.200.094 [Measuring arbor] and a
press to preload with 10 kN.
11. Place dial gauge at the inner surface.
12. Evenly lift the intermediate gear with a pry
bar and check the necessary setting of the
intermediate gear bearing 0.01 mm preload–
0.05 mm clearance.
If the required axial play is not reached,
replace the shim as specified below:
▪ In case of an insufficient axial play,
install a thicker shim.
▪ In case of an excessive axial play,
install a thinner shim.
13. Mark the installation position of the individual
parts.
14. Dismantle the individual parts.
Fig. 165
Assembly
EN 4472.751.001 - 2015-11
91
Summary of Contents for AV 133
Page 1: ...REPAIR INSTRUCTIONS AV 133 Bus axle with compact bearing BUSES...
Page 137: ......
