Operating Instructions
2K800/2K801/2K802
Initial
Installation
EN 4161.758.103m – 2015-10
15
3.3.3
Open design with adapter ring for
2K800 and 2K801
The adapter ring allows adaptation to different
connection dimensions. A seal is required on the
motor output shaft.
The adapter ring (5) and drive hub (1) are
delivered loose. Clean the fitting surfaces of the
motor (3) and drive hub (1). Check the motor shaft
(2) for axial and radial runout as described in
chapter 3.1. Also lightly grease the motor shaft.
After cleaning the fitting surfaces, place the
adapter ring onto the motor housing. Then heat
the drive hub to approx. 120 °C from the opening
and slide it onto the motor shaft (2) until it reaches
the stop.
Then check reference dimension “C” and change
using shims if necessary.
CAUTION
Risk of motor shaft damage if the hub is not
sufficiently heated.
Tighten the threaded pin (9) and secure it to
prevent it from turning, see chap. 3.4.
3.3.4
Open design with adapter ring for
2K802
The adapter ring allows adaptation to different
connection dimensions. A seal is required on the
motor output shaft.
The adapter ring (5) and drive hub (1) are
delivered loose. Clean the fitting surfaces of the
motor (3) and drive hub (1). Check the motor shaft
(2) for axial and radial runout as described in
chapter 3.1. Also lightly grease the motor shaft
(2).
After cleaning the fitting surfaces, place the
adapter ring onto the motor housing. Then heat
the drive hub to approx. 120 °C from the opening
and slide it onto the motor shaft (2) until it reaches
the stop.
Then check reference dimension “C” and change
using shims if necessary.
