Zgonc NEW GENERATION Yellow Garden Line YGL N.G...., Translation From The Original Instruction Manual

28

GB

12. Disposal and recycling

The equipment is supplied in packaging to prevent it from being damaged in transit. The raw materials in this packaging can 
be reused or recycled. The equipment and its accessories are made of various types of material, such as metal and plastic. 
Defective components must be disposed of as special waste. Ask your
dealer or your local council.

13. Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment 
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.

Important hint in case of sending the equipment to a service station:

Due to security reasons please see to it that the equipment is sent back free of oil and gas!

Fault

Possible cause

Remedy

The equipment does 

not start

•  Correct starting procedure not followed

•  Sooted or damp spark plug

•  Incorrect carburetor setting

•  Blade or nylon cutter mounted incorrectly

•  No fuel in the tank

•  Follow the instructions for starting

•  Clean the spark plug or replace it with a new one

•  Contact an authorized customer service outlet

•  Reassemble the blade or nylon cutter

•  Check the fuel level

The equipment starts 

but does not develop its 

full power

•  Incorrect choke lever setting

• 

Soiled air fi lter

•  Incorrect carburetor setting

•  Cutting blade blunt

•  Set the choke lever on the         position

• 

Clean the air fi lter

•  Contact an authorized customer service outlet

•  Have cutting blade resharpened /replaced

The engine does not 

run smoothly

•  Incorrect electrode gap on the spark plug

•  Incorrect carburetor setting

•  Clean the spark plug and adjust the electrode 

gap, or fi t a new spark plug

•  Contact an authorized customer service outlet

Engine smokes 

excessively

•  Incorrect fuel mix

•  Incorrect carburetor setting

•  Use the correct fuel mix (see fuel mixing table)

•  Contact an authorized customer service outlet

If the temperature of 

machines is too high

•  Engine is overloaded

•  Insure the machines have rest at regular time