www.zhonghangled.com/en
device
synchronous
7
Synchronous input port Connect PC Gigabit network
8
Receiver OUT2
Control large screen by splicing with receiver
OUT1
9
TF card port
Install SD card
Enlarge
storage
10
USB port
USB upload content
11
Audio port
Connect active speakers for audio output
12
PC port
Connect PC, 100M communication, used in both
screen adjustment and network communication
13
Signal indicator
Red indicator light indicates startup, green
indicator light indicates operation
The red light is
always on and
the green light
flashes slowly
14
Brightness-
Reduce brightness
15
Bri
Increase brightness
16
Test button
Test the LED screen
Test
whole
LED
screen,
13 mode
17
Sync/asynchronous
switch
Switch synchronous/asynchronous
18
WiFi antenna interface
19
RS485 port
Connect various sensors and environmental
capture cards
20
Sensor port
II. Create A New Screen
1. First, double clicking
to open the software, it will pops up a window to creating a new
screen. Choose the suitable model type ZH-EBOX300 in “ Screen Type ”. Adjust the width and
height of the screen, then click “OK ”.
