Part IV Setting Parameters
BECS-129S Singular-head Computerized Embroidery Machine
45
long stitch (no shorter than the set value) to two or more stitches according to
the value of “Jump Length”, and then jump to finish it.
Jump Length: (Options: 4.5, 6.5, and 8.5)
This is to set the division unit length which is used for dividing the long
stitches in embroidery or for dividing the long stitches into jump stitches in
design scaling up/down and rotation. Its measurement unit is mm.
4.8 Standard Trim Parameters
These are the parameters concerning the trimming in Flat embroidery.
Refer to the appendix for their options and default values.
Auto Trim: (Options: Yes, No)
This parameter is to decide whether the machine will trim automatically
at the end of embroidery or in the operations like color-changing and
over-frame. Some types of machines aren’t equipped with auto trim device.
Length After Trim: (Options: 1~7)
This parameter is to adjust the length of thread residue caused by
trimming. The smaller the parameter value is, the shorter the length of thread
Summary of Contents for BECS-129S
Page 4: ......
