K207A Swing Gate Opener User’s Manual
To install the front part, fit the hole in the front part with the hole in the supporting plate, and push the
axle pin into the holes (using hands or a hammer), and finally fit the retainer clip. See Fig. 7.
Fig. 7
Retainer clip
Front part of gate opener
Axle pin
Supporting plate
Wiring
Screw off the two stainless tapping screws, and then remove the cover and wiring as shown in Fig. 8.
WARNING: Follow the wiring diagram precisely. Failure to do so could cause damage to the gate
opener controller.
Fig. 8
M
V
U
W
Upper cover
Enlarge
Stainless tapping screw
