Trouble
Troubleshooting
●
Before contact an authorised service workshop, please check the following
points first.
Operation methods
●
For cleaning in corners and crevices you can use
crevice nozzle.(Fig.14)
Solution
The machine does not
start
1.Check to see if the power plug
is stably connected to the socket.
2.Check to see if the power
switch was turned on.
●
Turn the adjustable switch left or right to set up
absorbing or air blowing function
●
Please use upholstery brush for cleaning sofa, curtain
or dust on the decorating surfaces. Use floor nozzle for
common places such as carpet and floor.
（
Fig.15
）
●
Operation method for removing and cleaning the
filter
1.Check if the floor brush, hose
and extension tube were
clogged.
The suction power is
Possible cause
Remove the
obstruction in time,
empty the tank, clean
1
）
Hold on the lock on both sides of the product and
rotate it outwards to open. Then grasp the handle up to
carry out the motor head.
（
Fig.17
）
2.Check if the tank is full.
Turn left to the end the vacuum cleaner will be used for
absorbing and turn right to the end it will be used for air
blowing.
（
Fig.16
）
Adjustable switch
Insert the plug into
the socket again and
make sure that the
socket has power.
And turn on the
switch.
14
7
Model
Voltage
Frequency
ZN102-1
220~240V
50HZ
Range of power
1250W/1400W
The suction power is
reduced
empty the tank, clean
the filter and
reassemble the
extension tube.
carry out the motor head.
（
Fig.17
）
2
）
Grasp the handle with one hand and the filter with
the other hand and then rotate it counterclockwise to
remove.
（
Fig.18
）
2.Check if the tank is full.
3.Check if the filter is clogged,
the suction power switch is fully
turned on and extension tube is
connected correctly.
3
）
Clean the filter with running water first and then
slap it with hand or swing it. After removing the water
let it dried in the air or in the shade. Don
’
t dry it with
dryer in order to avoid deformation caused by high
temperature.
（
Fig.19
）
7
8
