19
When do you need to calibrate the stabilizer?
Please calibrate the stabilizer when necessary.
Calibration Reason
How to calibrate
1. A slight deviation is found in the tilt angle of the camera in level
position after startup.
2. A slight deviation is found in the roll angle of the camera in level
position after startup.
3. Frequent small angle correction is found when the camera is in
level position while the stabilizer stays still.
Initializing the
stabilizer
1. A slight deviation is found in the level position after the
initialization of the stabilizer.
2. The stabilizer has not been used for a long time.
3. The stabilizer undergoes significant temperature differences in
operating environments.
Six-side calibration
A slight deviation is found in the tilt or roll angle of the camera
in level position after initialization and six-side calibration of the
stabilizer.
Fine-tune motor
force
Initialization Method
1. Correctly install the batteries.
2. Hold the camera mounting plate with one hand, long-press the power button to
start up the stabilizer; long-press the POV mode button to enter standby mode while
keeping hold of the camera mounting plate through the whole process in case of
start-up failure.
3. Put the stabilizer still on a table surface, and wait for about 30 sec., and the stabilizer
will automatically complete initialization.
Calibration and Firmware Upgrade
