6381-A4 Router Users Guide
45
4.
Network Address Translation (NAT) and the Firewall options are enabled by default. Leave
these options enabled.
5.
If your DSL line is connected and your DSL provider is supporting DHCP, you can click the
Renew button and the router will retrieve an IP Address, Subnet Mask, and Default Gateway
address.
At any time you can renew the DHCP address by clicking on the Renew button.
6.
In the PVC Settings section, enter values for VPI and VCI as supplied by your ISP.
For more information, please see PVC Settings from the PPPoE Setup procedure.
7.
Select the quality of service (QOS).
Leave the default value if your ISP did not provide this information. Depending on the QoS
you select, you may also enter:
•
PCR
(Peak Cell Rate)
•
SCR
(Sustainable Cell Rate)
•
MBS
(Maximum Burst Size)
•
CDVT
(Cell Delay Variation Tolerance)
8.
To complete the connection click Apply.
The
Apply
button will temporarily save this connection. To make the change permanent,
click
Tools
(at the top of the page) and select
System Commands
. On the
System
Commands
page, click
Save All
.