Reference Guide
IMACS System Release 5.1.9
4-79
System Configuration and Operation
Checking the Time Slot Map
4.22
Checking the Time Slot Map
Once you select and assign the time slots, you can view the list of DS0 connections (the time
slot map) through the WAN card Cross-Connect Screen for cross-connect systems. You can
see the results of your assignments in the time slot map as follows:
1. From the Main Screen, select the WAN card in slot W-1.
2. Type “
x
” (
Xcon
) to bring up the time slot screen (see Figure 4-60 for T1 operation and
Figure 4-61 for E1 operation).
3. Selecting “
m
” (
Main
) to return users to the WAN card Main Screen.
4. Selecting “
m
” (
Main
) again will return users to the Main System Screen.
Figure 4-60. Typical Time Slot Screen for T1 Operation
For E1 transmission (Figure 4-61), time slot 0 and 16 are not available for assignment on
either the HSU table or the voice card time slots.
Like T1 operation in
d/i
mode, unspecified
time slots are
automatically
assigned to corresponding slots on the other WAN port on the
same card.
